Need help configuring your handheld Netum barcode scanner? It may be necessary to reset the scanner to factory defaults by scanning the following barcodes. It may be necessary to print this page to properly scan the barcodes. Please feel free to reference the linked PDF manuals as well.
Reset Newer Firmware Netum Barcode Scanner
Newer Firmware Netum Barcode Scanner PDF
Depending on the firmware installed in the Netum barcode scanner, you may need to scan both sets of 4 barcodes below in order to properly factory reset your scanner. If successful, you should hear normal beeps for the first 3 scans, followed by a longer more musical beep/noise. If you don’t hear the different success noise, try the other set of reset barcodes.
Reset Older Firmware Netum Barcode Scanner
Older Firmware Netum Barcode Scanner
Didn't hear the longer more musical style noise from scanning the above factory reset barcodes? It's possible that you have a scanner with older firmware. Try scanning the below barcodes to assist with obtaining factory settings. To further configure your Netum barcode scanner, feel free to reference the additional help article linked below.
Follow the rest of the instructions here to configure only PDF417 and QR code scanning:
ID scanner still not working properly?
If the ID scanner is only filling in the first check-in form field, try adding a fifth barcode to either grouping listed above. After completing numbers 1 - 4 of either grouping, add in the below barcode to be the fifth barcode in the scanning queue:
5. Combine-Key
